사운드 전용, 통신 채널인 I2S 스펙

by digipine posted Nov 02, 2017
?

Shortcut

PrevPrev Article

NextNext Article

ESCClose

Larger Font Smaller Font Up Down Go comment Print

1.0 INTRODUCTION

 

Many digital audio systems are being introduced into the consumer audio market, including compact disc, digital audio tape, digital sound processors, and digital TV-sound. The digital audio signals in these systems are being processed by a number of (V)LSI ICs, such as:

• A/D and D/A converters;
• digital signal processors;
• error correction for compact disc and digital recording; • digital filters;
• digital input/output interfaces.

Standardized communication structures are vital for both the equipment and the IC manufacturer, because they increase system flexibility. To this end, we have developed the inter-IC sound (I2S) bus – a serial link especially for digital audio.

 

2.0 BASIC SERIAL BUS REQUIREMENTS

 

The bus has only to handle audio data, while the other signals, such as sub-coding and control, are transferred separately. To minimize the number of pins required and to keep wiring simple, a 3-line serial bus is used consisting of a line for two time-multiplexed data channels, a word select line and a clock line.

Since the transmitter and receiver have the same clock signal for data transmission, the transmitter as the master, has to generate the bit clock, word-select signal and data. In complex systems however, there may be several transmitters and receivers, which makes it difficult to define the master. In such systems, there is usually a system master controlling digital audio data-flow between the various ICs. Transmitters then, have to generate data under the control of an external clock, and so act as a slave. Figure 1 illustrates some simple system configurations and the basic interface timing. Note that the system master can be combined with a transmitter or receiver, and it may be enabled or disabled under software control or by pin programming. 

 

첨부파일 참조

TAG •